Operation; Device Detection Page Definitions; Audio Loop Test - Grandstream Networks GSC3505 Series User Manual

LDAP Lookup For Sets the device to do the LDAP number searching when making outgoing calls. The default setting is
Dial "No".
LDAP Lookup For
Sets the device to do LDAP number searching for incoming calls. The default setting is "No".
Incoming Call
LDAP Dialing Configures the default account that being used when dialing LDAP contact. Users may choose the
Default Account Account 1-16, the default setting is "Default".
Recording
File name Displays the name of the recording file.
Duration Displays the duration of the device call.
Date Displays the date the call was recorded on.
Delete, Modify, lock or download the recording file.
Notes:

Operation

A recording file cannot be deleted if it is locked.
Users can delete a bench of recording files by clicking on "Delete".
Music
Audio File Address
Play Mode
Manual Operation
Auto Mode Play Time

Device Detection Page Definitions

Audio Loop Test

Available for the GSC3510 only
Audio loop test is used to test the three MICs available on the GSC3510. Each one of the MICs is tested separately.
Set up the stream's RTSP address. it supports playing audio files in .ts (.mp3) format. For
example: rtsp://ip_address/musicFile.ts.
Select the audio play mode:
● "Manual" (Default): Click Start/Stop to play/halt music. Music will automatically stop when
there is an incoming call, and will not continue to play after the end of the call.
● "Auto": The audio file will be played automatically. When there is an incoming call, the
audio file will stop playing and continue to play after the call.
Click to Play/Stop the stream: Only available on Manual Play mode.
When Play mode parameter is set to Auto, users can schedule the time and date to play the
audio file. This is by configuring the Cycle Time parameter (Appears only when Play mode is
set to Auto). This parameter can either be set to All days, this will then trigger the function all
days. Or to Period of Time, which will trigger the function on the period of time according to
the user's schedule. The default value is All days.