Calls Page Definition - Grandstream Networks GSC3505 Series User Manual

Loads the MOH file to the device. Click on "Browse" button to upload the music file from local PC. The
Upload Local
MOH audio file has to be in .wav or .mp3 format.
MOH Audio
File
Note: Please be patient while the audio file is being uploaded. It could take more than 3 minutes to
finish the uploading especially the file size is large. The button will show as "Processing" during the
(Music on
uploading. Once done, it will show as "Browse" again. Click on "Save" on the bottom of the web page
Hold)
and "Apply" on the top of the web page to save the change.
Enable Local
Plays local MOH file if the call is being hold by the device. Default is "No".
MOH
Advanced
Features
It is used to set to categorize accounts in server mode groups, the accounts in the same group will be
combined as one and the account widget will display the Caller ID in the account with lowest ID. The
device can answer any incoming calls to each account in groups.
Virtual
If user makes an outbound call, the device will use the lowest ID account by default. If the account fails or
Account
SIP INVITE message is timeout, the device will failover to the next account in the group with higher
Group
account ID.
If all the accounts are not available in the group, the device will traverse all the accounts in the group and
notify the users the session is failed.
Configures phone's settings to meet different vendors' server requirements.
Special
Users can choose from Standard, NEC, WorldStone, BroadSoft, China Mobile, ZTE IMS, Mobotix or ZTE
Feature
NGN depending on the server type.

Calls Page Definition

Call
This page is available for the GSC3510 only.
The GSC3510 allows users to manage their calls using the Click to Dial feature which permits to initiate and receive calls using
the Web GUI. To use the Click to Dial feature, please refer the following steps:
1. Go under the GSC3510 Web GUI �� Calls �� Call.
2. Select the account to be used.
3. Type the number / IP Address to call and press Dial button as displayed on the following screenshots:
Figure 30: Click-to-Dial Feature