Mounting The Camera (Optional Vhs Adaptor) - Vinten Vision 100 Operator's Manual

.
Mounting the camera (VHS adaptor)

Mounting the camera (optional VHS adaptor)

The optional VHS adaptor
connected by a plastic link.
To mount the camera using the VHS adaptor, proceed as follows:
Remove the slide plate
the slide lock release
Remove the two 3/8 in. BSW camera mounting screws
Position the VHS
wards. Screw the pin securely into the slide plate.
Secure the slide plate to the camera with the 1/4 in. BSW camera mounting screw, ensuring
the pin engages in the hole in the camera.
Set the platform level and apply both the pan and tilt brakes (5)(7).
Push the slide plate and camera into the track in the platform, ensuring the slide lock re-
lease (8) snaps into position.
Balance the head
(10)
(8)
(22) consists of a VHS pin and a 1/4 in. BSW camera mounting screw
(9) from the head by releasing the slide plate clamp (10), pressing
(8) and pulling the plate out to the rear.
(22) adaptor in the longer slot in the slide plate, with the pin facing for-
(See Balancing the head).
(9)
(22)
(2)
(2) from the slide plate.
11