Mounting The Camera (3/8 In. Mounting Screws) - Vinten Vision 100 Operator's Manual

Mounting the camera (optional Quickfit adaptor)
Mounting the camera (optional Quickfit adaptor)
If not already attached, secure the Quickfit Adaptor
(2) provided.
Free the Quickfit wedge
(21) and operating the wedge release (20).
Fit the Quickfit wedge to the camera with the two screws
Insert the forward end of the wedge into the forward end of the adaptor. Lower the rear of the
wedge into the adaptor until an audible click indicates that the wedge is locked in position.
Balance the head (See Balancing the
(2)
(18) from the adaptor by simultaneously pushing in on the safety catch
head).
(17)
(18)
(19)
(20)
(21)
(9)
(19) to the slide plate
(17) provided.
(9) with the two screws
10