Electronic Controls - Volvo Penta D13 Series Operator's Manual

Instruments and Controls
42

Electronic controls

Engine and drive features are controlled with push
buttons on the control. The buttons and functions
available depend on the installation.
1 STATION
The button lamp is lit if the helm station is active.
See the chapter entitled Helm Stations for further
information.
2 CRUISE CONTROL (optional)
Switch on cruise control by pressing the button (2).
Fine tune the locked engine speed by increasing (+)
or reducing (-) engine rpm with the button at the
back of the control.
3 LOW SPEED (optional)
See the chapter entitled Optional, page 45 for
information about the Lowspeed function.
4 THROTTLE ONLY
By activating THROTTLE ONLY, the shift function
is disconnected and the control lever only affects
the engine speed.
5 SINGLE LEVER (optional)
Switch on the single lever function by pressing the
button. The lever that is moved from its position first
becomes the control lever for both engines. The
other control lever has no function as long as the
single lever function is activated. The button lamp
lights up to show that the function is active. Exit the
single lever function by pressing the button again.
6
Neutral position. The symbol shows that the drive/
reverse gear is disengaged.
7
The warning triangle lights up if the system
discovers a fault. See the chapter entitled Fault
Handling for more information about system faults.
The warning triangle lights up on the same side as
the driveline with the indicated fault.
8 This function is not available.
9 TRIM ASSIST
Switch on the automatic interceptor control
functionality by pressing the button (9). The
interceptors are then automatically adjusted when
needed.
10 TRIM
Manually adjust the interceptors. Manual
adjustment using the TRIM button (10) will override
the automatic function, if enabled.
For twin engine installations, the adjustment of the
drives are synchronized.
47708638 09-2016 © AB VOLVO PENTA