Drive Straight Calibration - Volvo Penta D13 Series Operator's Manual

Calibration and Settings
NOTICE! This calibration only needs to be performed if the boat does not travel straight after mechanical
installation.
1. Move all controls to
neutral.
5. Manufacturer
Calibrations > Rudder
Steering.
7. Press THROTTLE
ONLY to confirm rudder
position.
136
2. Turn the ignition on.
6. Follow instructions on
screen.
8. Ignition must be
turned off for at least 15
seconds to confirm the
calibration.

Drive Straight calibration

3. THROTTLE ONLY:
press and hold for at
least 5 seconds.
7. If rudder end positions
are calibrated: Start
engines to perform
Drive Straight
Calibration
47708638 09-2016 © AB VOLVO PENTA
4. Turn the steering wheel
to enter Calibration mode.
Drive Straight Calibration
started. Keep speed below
planning threshold and the
direction straight forward.
8. Follow instructions on
screen.