7: Jumpstart Auto-Programming; Restore Defaults; Voice Options; 1: Vcm Maintenance - Honeywell 6820 Manual

Restore Defaults

4. Select 8 for SLC Family.
5. Press UP arrow to select the desired SLC device type.
6. Press ENTER to accept the displayed SLC device type.
NOTE: When you change the SLC type from one protocol to another, the following message will appear.
When changing SLC family from SK to SD will remove all external 6815 modules. When changing from SD to SK SLC family will remove
all 5815XL modules on the system.
8.6.7 JumpStart Auto-Programming
NOTE: JumpStart Auto-Programming is used to auto learn the system hardware after devices have been added or removed from the system.
Hardware devices which remain the same between repeat JumpStart will retain any customized text or options associated with the device. It is
best to carefully consider the Network ID setting for each panel before the first JumpStart Auto-Programming is performed. Once this is done,
the panel must be defaulted back to factory defaults if the network ID settings need to change.
To run JumpStart, do the following.
1. Login to the panel. The panel will automatically go to the Main Menu.
2. Select 7 for Panel Programming.
3. Select 6 for JumpStart.
4. Press ENTER to accept the warning screen.
5. Follow the remaining on screen instructions.
6. Press ENTER to confirm. See Section 7.1.3.
8.7 Restore Defaults
This option allows you to restore the panel back to factory defaults. All programming will be lost.
1. Login to the panel. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 7 for Restore Defaults.
4. Press the up or down arrow key to select YES or NO from the warning screen. Then, press ENTER.

8.8 Voice Options

Through this Programming Menu, you can modify the messages programmed into an EVS-VCM. You can also modify other voice settings.
8.8.1 VCM Maintenance
The VCM Maintenance menu is used to program custom messages into the VCM. Messages can be recorded locally using the microphone.
1. Select 7 for Panel Programming.
2. Select 8 for Voice Options.
3. Select 1 for VCM Maintenance.
8.8.2 Voice Settings
1. Select 7 for Panel Programming.
2. Select 8 for Voice Options.
3. Select 2 for Voice Settings.
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
Changing the SLC
family will set all
SLC points to
[Press for More]
Figure 8.12 SLC Family Change
family will set all
SLC points to
UNUSED
Back Accept
Programming
109