Ikegami HTM-1517R Operation Manual page 30

a) APT PRESET switch
Set the APT switch on the front panel to ON.
b) HUE PRESET switch
When the HUE MANUAL switch on the front panel
is ON, set it to PRESET. The switch is enabled only
when the NTSC composite signal is selected.
c) CHROMA PRESET switch
When the CHROMA MANUAL switch on the front
panel is ON, set it to PRESET.
d) BRGHITNESS PRESET switch
When the BRIGHT MANUAL switch on the front
panel is ON, set it to PRESET.
e) CONTRAST PRESET switch
When the CONT MANUAL switch on the front
panel is ON, set it to PRESET.
⑦ CLEAR switch
Press this switch to select the item you want to
change or clear the data in the PRESET screen dis-
played by operating the CHANGE PRESET switch
and the WHITE BALANCE switch.
While changing any preset data, press this switch
to clear the new data and restore the previous one.
⑧ H. CENT switch
Switch for adjusting the horizontal position of the
active screen.
⑨ V. CENT switch
Switch for adjusting the vertical position of the ac-
tive screen.
⑩ ROTATION switch
Switch for correcting deviation of PURITY due to
geomagnetic effects when the monitor orientation
is changed. Set the screen to one color using the
SCREEN switch and adjust so that the entire screen
becomes one even color.
In the application where the monitor is rotated con-
stantly such as on OB van, set the EL bit connector
(EL561) on the DEF board to OFF to deactivate the
ROTATION circuit.
This connector is set to ON as factory setting.
⑪ WIDTH switch
Switch for adjusting the width of the active screen
by scan size and aspect.
⑫ HEIGHT switch
Switch for adjusting the height of the active screen
by scan size and aspect.
⑬ MK. PHASE switch
Switch for adjusting the horizontal phase of the
marker.
Adjust so that the image fits inside the 100% frame.
⑭ APT PRESET switch
Switch for adjusting the aperture.
This switch will not function unless the APT switch
on the front panel is set to ON (LED is ON).
⑮ EXPAND switch
Switch for adjusting the SIDE PIN, TRAPEZOID
and MOIRE.
Each time the switch is pressed, TRAPEZOID, SIDE
PIN and MOIRE alternates.
(TRAPEZOID)
⑯ R. BACKGROUND switch
Switch for adjusting the low light white balance (red
component).
For details of the adjustment, refer to 4-6 (3).
⑰ G. BACKGROUND switch
Switch for adjusting the low light white balance
(green component).
For details of the adjustment, refer to 4-6 (3).
22
(SIDE PIN)