Table of Contents
Advertisement
5. Installation
Caution :
This installation should be made by a qualified service person and
should conform
to all local codes.
Avertissement :
Cette installation doit se faire par une personne de service qualifie
et doit conformer tous les codes locaux.
5-1
Connection
with
External
Equipment
@ VIDEO
INPUT
A/B
Q Termination
Switch
Apply a video signal to the connectors (D. Video A and B are
selectively used and switchalbe
with the front switch
refer to
6. Routine Adjustment.
Bridge connection is permitted for each
input. When
bridge connection is not used, set the termination
switches) to the 75Q position.
@ SYNC
INPUT
@ Termination Switch
Connect
a
sync
signal
to
this
connector @
for
external
synchronization. Bridge connection
is permitted
for this input.
When
bridge connection
is not used, set the termination switch
@ to 75Q position.
© REMOTE
VIDEO
А/В
and
SYNC
INT//EXT
select and
Red
tally are
controlled externally
with the supplied connector.
For details, refer to 5-2 Connection of Remote Connector.
© POWER
INPUT
Connect the supplied AC power cable to this terminal to supply
single- phase AC120 V/60 Hz.
5-2
Connection
of Remote
Connector
The
connection
shown
below
permits
external
controls
for VIDEO
and SYNC
select and
the red taliy.
|мен» зіде
$-1808A
РЕ-1608А
01 | GROUND
О2
| SYNC
CONTROL
O3|Red TALLY
ON at short
Connecting
method
of remote
connector
Advertisement
Table of Contents
