Table of Contents
Advertisement
CHAPTER 12
Grounding the CSE2000
Tools and Parts Required to Ground the CSE2000
Related
Documentation
Connecting the CSE2000 Grounding Cable
Copyright © 2014, Juniper Networks, Inc.
Tools and Parts Required to Ground the CSE2000 on page 47
Connecting the CSE2000 Grounding Cable on page 47
To ground the CSE2000, you need the following tools and parts:
ESD grounding wrist strap (not provided)
Four 8-32 nuts—two nuts each are fastened to the two earthing bolts on the rear panel
of the chassis when shipped
Grounding lug
Grounding cable
CSE2000 Rear Panel Features on page 9
CSE2000 Chassis Grounding Cable and Lug Specifications on page 15
Connecting the CSE2000 Grounding Cable on page 47
Prevention of Electrostatic Discharge Damage on CSE2000 on page 36
BEST PRACTICE:
the chassis. See
To connect the grounding cable:
Make sure that grounding surfaces are clean before grounding connections are made.
1.
Connect the grounding cable to a proper earth ground.
2.
Verify that a licensed electrician has attached the cable lug provided with the CSE2000
3.
device to the grounding cable.
The grounding points for the CSE2000 are at the rear of
"CSE2000 Rear Panel Features" on page
9.
47
Advertisement
Table of Contents
