Cse2000 Front Panel Features; Figure 1: Cse2000 Front Panel Features; Table 3: Cse2000 Front Panel Features - Juniper CSE2000 Hardware Installation Manual

Table of Contents

Carrier-Grade Service Engine CSE2000 Hardware Installation Guide

Table 2: CSE2000 Chassis Features (continued)

CSE2000 Front Panel Features

Specification

When the device is cool, the fans spin at a slower speed to reduce noise and save energy.

As the device heats up, the fans run at a faster speed. In the event of fan failure, the

fault LED blinks and the remaining fan or fans run at full speed.

Removable AC power supply standard: 100 VAC to 240 VAC, 47––63 Hz, 15.0 amperes

(A)maximum. Standard IEC power cord is provided for AC power supply.

Removable DC power supply is an available option: –45 VDC to –60 VDC, 35 A maximum.

NOTE:

AC and DC power supplies are not supported simultaneously.

CAUTION:

The CSE2000 is NEBS compliant and the fan speed is optimized

for balancing acoustic and cooling conditions based on the system

configurations. Removing any dummy cover or removable component, such

as tray or redundant power supply, changes the system air flow and might

cause overheating of certain components.

CSE2000 Front Panel Features on page 6

CSE2000 Rear Panel Features on page 9

Figure 1 on page 6

shows the CSE2000 front panel features.

the front panel LEDs.

Table 4 on page 7

describes the connectivity ports on the CSE2000.

Table 3 on page 6

lists the front panel features of CSE2000.

Number

Component

LOCATOR

LED and button. The LED can be turned off by pressing the button.

Table 4 on page 7

describes the front panel LEDs.

describes

Table of Contents