Connecting Ac Power To An Mx150; Figure 16: Connecting A Grounding Cable To An Mx150 - Juniper MX150 Hardware Manual

Connecting AC Power to an MX150

Copyright © 2019, Juniper Networks, Inc.

Figure 16: Connecting a Grounding Cable to an MX150

Secure the grounding lug to the protective earthing terminal with the washers and
3.
screws.
Dress the grounding cable and ensure that it does not touch or block access to other
4.
device components.
WARNING: Ensure that the cable does not drape where people could trip
over it.
The power supply in an MX150 is located on the rear panel.
Ensure that you have the following parts and tools available:
A power cord appropriate for your geographical location
A power cord retainer clip
CAUTION: An MX150 gets additional grounding when you plug the power
supply in the device into a grounded AC power outlet by using the AC power
cord appropriate for your geographical location (see
Specifications for an MX150" on page
To connect AC power to the device:
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
1.
of the wire clip into the holes in the bracket on each side of the AC power cord inlet
on the rear panel.
The power cord retainer clip extends out of the chassis by 3 in. (7.62 cms).
Locate the power cord or cords shipped with the device; the cords have plugs
2.
appropriate for your geographical location. See
MX150" on page 25.
Chapter 3: Initial Installation and Configuration
"AC Power Cord
25).
"AC Power Cord Specifications for an
55