Installing The Dxp - YOKOGAWA DAQSTATION DX100P Operation Manual

Installing the DXP

Installation Location
Installation Procedure (Panel Mount Type)
8
Install the DXP in a location that meets the following conditions.
• To prevent overheating, install the DXP in a well-ventilated location.
For the desktop type, a space of 50 mm or more from the right, left and top surface of
the DXP is recommended.
• Choose an installation location with the minimum mechanical vibration.
• Install the DXP horizontally (However, the DXP can be inclined up to 30 degrees
backwards for panel mounting).
Do not install the DXP in the following places:
• In direct sunlight or near heat sources
Install the DXP in a place with small temperature fluctuations near room temperature
(23°C). Placing the DXP in direct sunlight or near heat sources can cause adverse
effects on the internal circuitry.
• Where an excessive amount of soot, steam, moisture, dust, or corrosive gases
are present
Soot, steam, moisture, dust, and corrosive gases will adversely affect the DXP. Avoid
such locations.
• Near strong magnetic field sources
Do not bring magnets or instruments that produce electromagnetic fields close to the DXP.
Operating the DXP in strong magnetic fields can cause errors in the measurements.
• Bad angle for viewing the screen
Because the DXP uses a TFT color LCD, it is difficult to view the display from an
extreme angle. Please install the DXP so that the monitor can be viewed from the front.
The DXP should be mounted on a steel panel of thickness 2 mm to 26 mm.
1.
Insert the DXP from the front side of the panel.
2.
As shown in the figure below, mount the DXP to the panel using the mounting
brackets that came with the package.
• Use two brackets to support the top and bottom or the left and right sides of
the case. (Remove the seal that is covering the holes for the mounting
brackets beforehand.)
• The proper torque for tightening the mounting screws is 0.8 to 1.2 Nm.
Tightening the screws too much can deform the case or damage the bracket.
DX100P
CAUTION
2 mm to 26 mm
Mounting bracket (B9900BX)
DX200P
2 mm to 26 mm
IM 04L05A01-02E