Table of Contents
Advertisement
2.1 Overview
This chapter provides advice and instructions for rack or workstation installation. If your system
is not already fully integrated with processors, system memory, etc., refer to
details on installing those specific components.
Caution: Electrostatic Discharge (ESD) can damage electronic components. To prevent such
damage to PCBs (printed circuit boards), it is important to use a grounded wrist strap, handle
all PCBs by their edges and keep them in anti-static bags when not in use.
2.2 Unpacking the System
Inspect the box in which the SuperWorkstation SYS-531A-I was shipped, and note if it was
damaged in any way. If any equipment appears damaged, file a damage claim with the carrier
who delivered it.
Decide on a suitable location for the workstation. It should be situated in a clean, dust-free
area that is well ventilated. Avoid areas where heat, electrical noise and electromagnetic
fields are generated. It will also require a grounded AC power outlet nearby. Be sure to read
the precautions and considerations noted in
2.3 Preparing for Setup
Please read this section in its entirety before you begin the installation.
Choosing a Setup Location
•
Leave enough clearance in front and back of the system to allow sufficient airflow and
access when servicing.
•
This product is not suitable for use with visual display workplace devices according to
§2 of the German Ordinance for Work with Visual Display Units.
Workstation Precautions
•
Review the electrical and general safety precautions in
Chapter 2
Workstation Installation
17
Chapter 2: Workstation Installation
Appendix
A.
Appendix
Chapter 3
for
A.
Advertisement
Table of Contents
Troubleshooting
