Supermicro SuperWorkstation SYS-531A-I User Manual page 42

Figure 3-6. Remove a Drive Carrier from the Cage
6. If a hard drive is already present, pull the sides of the carrier and remove the drive from
the carrier.
7. Insert a new drive into the carrier and push the sides of the carrier together.
8. Insert the carrier into the cage. Slide the carrier towards the back of the cage until it
clicks into place.
9. If desired, each carrier may be secured to the exterior of the hard drive cage using one
optional screw.
10. Connect the hard drive cables.
11. Rotate the cage 90 degrees inward.
Chapter 3: Maintenance and Component Installation
1
6
42
1
6
Release Tab