BRP Sea-Doo GTX PRO 130 Operator's Manual page 74

EQUIPMENT
W W a a t t e e r r t t i i g g h h t t C C o o m m p p a a r r t t m m e e n n t t
Inside the glove box is located a small
watertight storage compartment for
personal articles. Pull backwards on
the two latches to open.
T T Y Y P P I I C C A A L L
There is a protective foam located in-
side the watertight compartment to
protect a phone from damages. Make
sure the smartphone is held in place
by the foam and not the edges of the
receptacle and that you can close the
lid. Always make sure the foam is
completely dry before using.
Refer to Maximum Phone Size chart.
M M a a x x i i m m u u m m P P h h o o n n e e S S i i z z e e
Length
Width
N N O O T T E E : :
Due to variation in smartphone sizes
and cases styles, ensure there is no
pressure on connector and/or phone
when closing the lid.
72
160 mm (6.3 in)
85 mm (3.3 in)
Some models are equipped with a
USB port used for charging. When us-
ing the USB port to charge a smart-
phone, always make sure to route the
cable such that there is no pressure
on either ends of the cable to prevent
damage to cable or smartphone
connectors.
N N O O T T E E : :
For optimum performance, always
use OEM USB cables. Low cost after-
market cables may not have data lines
and/or higher impedance which may
result in poor charging performance or
overheating.
Many models of smartphones have a
brittle female connector so extra care
should be taken when inserting in the
watertight compartment. BRP recom-
mends to use a short cable (no more
than 25 cm (10 in)) so there is less ex-
tra cable length to stow.
The models not equipped with USB
charging port are instead equipped
with a rubber seal to ensure water-
tightness. There is a ventilation mem-
brane that balance pressure inside
and outside the compartment to en-
sure it can be opened without suction-
ing water droplets
membrane itself is watertight. Water-
tightness of the compartment is finally
ensured by pressing the compart-
ment's door on the surrounding seal,
using the two latches.
To ensure that articles inside the com-
partment are protected from the envi-
ronment,
recommendations should be followed:
Before and during use:
– Make sure the seal is intact,
cleared and properly positioned.
– Make sure the ventilation mem-
brane is intact and properly
positioned.
– Make sure the seal around the
USB charging port (or rubber seal)
is intact and properly positioned.
inside.
the following
The