BRP Sea-Doo GTX PRO 130 Operator's Manual page 125

Using the flushing connector, inject
pressurized air at 379 kPa (55 lbf/in²)
into system until there is no more
water flowing from jet pump.
1. Flushing connector
The following hose can be fabricated
to ease draining procedure.
T T Y Y P P I I C C A A L L
1. Flushing connector adapter
2. Hose 12.7 mm (1/2 in)
3. Air hose male adapter
N N O O T T I I C C E E
F F a a i i l l u u r r e e t t o o d d r r a a i i n n t t h h e e e e x x h h a a u u s s t t s s y y s s - -
t t e e m m m m a a y y c c a a u u s s e e s s e e v v e e r r e e d d a a m m a a g g e e t t o o
t t h h e e e e x x h h a a u u s s t t m m a a n n i i f f o o l l d d . .
Remove special tools.
L L u u b b r r i i c c a a t t i i n n g g t t h h e e E E n n g g i i n n e e C C y y l l i i n n d d e e r r s s
1. Remove spark plugs. Refer to
Maintenance Procedures section.
2. Spray lubricant in each cylinder
through spark plug holes.
S S e e r r v v i i c c e e P P r r o o d d u u c c t t
XPS Anti-Corrosive Lubricant or
equivalent
3. Fully depress the throttle lever. De-
pressing the throttle lever will
STORAGE AND PRESEASON PREPARATION
prevent fuel from being injected
and disable the ignition during en-
gine cranking.
4. Press the START/STOP button to
crank the engine a few turns. This
will distribute the oil on the cylinder
walls.
5. Apply anti-seize lubricant on spark
plug threads, then reinstall them in
the engine. Refer to Maintenance
Procedures section.
6. Install the ignition coils. Refer to
Maintenance Procedures section.
T T e e s s t t i i n n g g t t h h e e E E n n g g i i n n e e C C o o o o l l a a n n t t D D e e n n s s i i t t y y
If antifreeze is not replaced, test its
density.
The antifreeze replacement and a
density test should be performed by
an authorized Sea-Doo dealer, repair
shop or person of your own choosing.
Refer to Maintenance Schedule .
N N O O T T I I C C E E
I I m m p p r r o o p p e e r r a a n n t t i i f f r r e e e e z z e e d d e e n n s s i i t t y y m m a a y y
r r e e s s u u l l t t i i n n f f r r e e e e z z i i n n g g o o f f t t h h e e l l i i q q u u i i d d i i n n
t t h h e e c c o o o o l l i i n n g g s s y y s s t t e e m m i i f f t t h h e e w w a a t t e e r r - -
c c r r a a f f t t i i s s s s t t o o r r e e d d i i n n a a n n a a r r e e a a w w h h e e r r e e
t t h h e e f f r r e e e e z z i i n n g g p p o o i i n n t t i i s s a a t t t t a a i i n n e e d d . . T T h h i i s s
w w o o u u l l d d s s e e r r i i o o u u s s l l y y d d a a m m a a g g e e t t h h e e
e e n n g g i i n n e e . .
E E l l e e c c t t r r i i c c a a l l S S y y s s t t e e m m
B B a a t t t t e e r r y y
B B a a t t t t e e r r y y M M a a i i n n t t e e n n a a n n c c e e
When storing the watercraft, the bat-
tery should always be stored in a
warm, dry place.
W W A A R R N N I I N N G G
N N e e v v e e r r c c h h a a r r g g e e o o r r b b o o o o s s t t t t h h e e b b a a t t t t e e r r y y
w w h h i i l l e e i i n n s s t t a a l l l l e e d d i i n n t t h h e e w w a a t t e e r r c c r r a a f f t t . .
This vehicle is equipped with a main-
tenance-free type battery, there is no
123