BRP Sea-Doo GTX PRO 130 Operator's Manual page 116

MAINTENANCE PROCEDURES
T T Y Y P P I I C C A A L L
With watercraft on a level surface,
coolant level should be between
MIN. and MAX. marks on coolant
reservoir when engine is cold.
C C O O O O L L A A N N T T E E X X P P A A N N S S I I O O N N T T A A N N K K
1. Level between marks when engine is cold
N N O O T T E E : :
The watercraft is level when it is in
water. When on a trailer, raise trailer
tow pole and block in this position
when bumper rail is level.
Add coolant, see Recommended
Engine Coolant for specification, to
adjust coolant
marks as required. Use a funnel to
avoid spillage. Do not overfill.
3. Properly tighten the expansion
tank cap. Reinstall seats.
N N O O T T E E : :
A cooling system that frequently re-
quires coolant is an indication of leaks
or engine problems. See an author-
ized Sea-Doo dealer.
114
level between
E E n n g g i i n n e e C C o o o o l l a a n n t t R R e e p p l l a a c c e e m m e e n n t t
Coolant replacement should be per-
formed by an authorized Sea-Doo
dealer.
I I g g n n i i t t i i o o n n C C o o i i l l s s
I I g g n n i i t t i i o o n n C C o o i i l l A A c c c c e e s s s s
1. Remove tether cord from the en-
gine cut-off switch.
2. Remove seat(s).
3. Remove engine service cover by
removing the retaining screws.
R R e e m m o o v v i i n n g g t t h h e e I I g g n n i i t t i i o o n n C C o o i i l l
1. Disconnect ignition coil connector.
N N O O T T I I C C E E
D D o o n n o o t t p p r r y y o o n n i i g g n n i i t t i i o o n n c c o o i i l l u u s s i i n n g g
a a n n y y t t o o o o l l . .
2. Remove ignition coil retaining
screw.
3. Remove ignition coil from spark
plug by rotating coil side to side as
you pull up.
I I n n s s t t a a l l l l i i n n g g t t h h e e I I g g n n i i t t i i o o n n C C o o i i l l
1. Align the retaining screw hole of
the ignition coil with the threaded
hole on the valve cover.
2. Install the ignition coil on the spark
plug and push it all the way down
until it rests on the valve cover.