BRP Sea-Doo GTX PRO 130 Operator's Manual page 75

– Completely dry the compartment
and its contents before closing.
– Make sure nothing gets pinched
between cover and box when clos-
ing compartment.
– Always close the compartment
completely using the 2 latches.
After use:
– Remove smartphone from
compartment.
– The USB charging port's inte-
grated rubber cap should be in-
stalled to cover the connector.
– Always close the compartment
completely using the 2 latches.
N N O O T T E E : :
Use of desiccant in the watertight
compartment is recommended to
eliminate condensation. Replace des-
iccant frequently.
S S e e a a t t
This model comes equipped with an
ergonomic seat narrowing towards the
front with knee grab design allowing
you to position your legs towards the
inside of the footwells, minimizing
upper body fatigue and granting you
more control when cornering.
E E R R G G O O N N O O M M I I C C S S E E A A T T
R R e e m m o o v v i i n n g g t t h h e e S S e e a a t t
1. Push on the two release buttons
and lift the back end of the rear
seat.
2. Then pull the latch handle up and
remove the front seat from the
watercraft.
I I n n s s t t a a l l l l i i n n g g t t h h e e S S e e a a t t
1. To install the seat, insert the for-
ward end of the front seat in its
retainer.
S S E E A A T T R R E E T T A A I I N N E E R R
2. Push the rear end of the front seat
down to lock it.
3. Pull upwards on the front seat to
make sure it is locked in place.
4. Insert the forward part of the rear
seat into the retainers.
EQUIPMENT
73