Installing The Sc Board; Installing The Solaris™ 8 Os On The Sc Board - Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual

3. At the prompt, change the directory to the CD-ROM's root.
EMS-Server8:/ [root] => cd /cdrom/cdrom0
4. If there is no directory,"cdrom0" exists, type the command, eject and try again.
EMS-Server8:/ [root] => eject
5. At the prompt, run the 'install' script by typing ./install and pressing Enter.
EMS-Server8:/cdrom/cdrom0 [root] => ./install
The Install image creates a /jumpstart directory that is shared over the network.
21.4

Installing the SC board

21.4.1.1 Installing the Solaris™ 8 OS on the SC board
To install the Solaris™ 8 OS on the SC boards, take these 9 steps:
1. On SC board, connect to the RS232 console.
2. Identify the SC hostname, IP address and MAC address of the SC board.
Sample values are shown in red in the example below.
client224:~# ~ => ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
dmfe0:
flags=1000863<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,IPv4> mtu
1500 index 2
inet
ether
3. On the 'Install Server', open a terminal (via Telnet or X).
4. Define the SC board.
EMS-Server8:/ [root] => cd /jumpstart/Solaris_8_202_v1.0
EMS-Server8:/ [root] => ./add_client.sh sc_name sc_ip sc_mac
Installation, Operation, Maintenance Manual
10.7.13.94 netmask ffff0000 broadcast 10.7.255.255
0:3:ba:78:8e:65
214
Media Gateway 3500
Document # LTRT-90704