Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual page 218

1. Using FTP, from the MG 3500 software installation CD, copy the fk_update.pl
script to the root directory on the Active SC board.
2. Using Telnet or the RS232 console, connect to the Active SC board.
3. Change the permissions of the fk_update.pl script by typing at the prompt:
chmod a+x /fk_update.pl
4. Run the fk_update.pl script in dump mode, by typing at the prompt:
/fk_update.pl dump
The script analyzes the feature key on each of the Media Gateway boards. If any
of the feature keys are invalid, the script collects all of the required information
and creates a report. If such a report is produced, send it to Nortel Technical
Support who will provide a file containing the correct keys for your Media
Gateway boards.
5. Transfer this update file to the Active SC board and apply it by typing at the
prompt:
/fk_update.pl <key_filename>
Note:
Installation, Operation, Maintenance Manual
Feature keys go into effect only after Media Gateway boards are restarted.
Optionally, from the EMS, lock/unlock Media Gateway boards after this
Feature key update. However this is not a mandatory step, since boards
are reset during Online Software Upgrade.
218
Media Gateway 3500
Document # LTRT-90704