Table of Contents
Advertisement
Installation, Operation, Maintenance Manual
To install the SC software, take this step:
Following the directions in 'Configuring System Controller Software for the First Time'
on page 83, connect the console terminal to the SC board.
14.2.3
SC Installation Package
The SC installation package is provided on Media Gateway 3500 System Software
Installation CD included in the accessory kit accompanying the Media Gateway 3500 . The
following are the software components on the CD:
Directory
root directory
14.2.4
Copying the SC Software
To copy the SC software, take these 4 steps:
Via the IP network, connect to the SC-2 board from the PC terminal using Telnet.
Note 1:
Note 2:
1.
Copy the installation package from the SC software CD to the SC-2 board using the
example below. This can be performed using FTP.
Note:
Example for copying the file:
Entered text is shown in bold and the IP address of the SC-2 board is assumed to be
10.1.2.3.
~> cd <directory of files>
2.
Use the dir command to identify the installation package files
Version 3.0
Table 14-1: SC Installation Package Files
File
sc_software.tar.gz
Ensure that the PC terminal you are using is connected to the same IP
network to which the Media Gateway 3500 is also connected.
If for any reason you cannot establish a connection via the IP network, you
can alternatively connect via one of the five RJ-45 ports in the Ethernet
Switch RTM provided in the optional integration kit.
The installation package files of more than one product may be provided on
the CD you receive. Be sure to select the directory and installation package
files appropriate for your system.
14. Hardware Replacement Procedures
Description
The tar file containing compressed SC software and
related files
147
October 2005
Advertisement
Table of Contents
Troubleshooting
