Newland NLS-HR20-BT User Manual page 202

Enable/Disable Data Formatter
When Data Formatter is disabled, the barcode data is outputted to the host as read, including prefixes and suffixes.
You may wish to require the data to conform to a data format you have created. The following settings can be applied to
your data format:
Enable Data Formatter, Required, Keep Prefix/Suffix: Scanned data that meets your data format requirements is
modified accordingly and gets outputted along with prefixes and suffixes (if prefix and suffix are enabled). Any data that
does not match your data format requirements generates an error beep (if Non-Match Error Beep is turned ON) and the
data in that barcode is not transmitted.
EnableDataFormatter,Required,DropPrefix/Suffix:Scanneddatathatmeetsyourdataformatrequirementsismodified
accordingly and gets outputted without prefixes and suffixes (even if prefix and suffix are enabled). Any data that does not
match your data format requirements generates an error beep (if Non-Match Error Beep is turned ON) and the data in that
barcode is not transmitted.
Enable Data Formatter, Not Required, Keep Prefix/Suffix: Scanned data that meets your data format requirements is
modifiedaccordinglyandgetsoutputtedalongwithprefixesandsuffixes(ifprefixandsuffixareenabled).Barcodedatathat
doesnotmatchyourdataformatrequirementsistransmittedasreadalongwithprefixesandsuffixes(ifprefixandsuffixare enabled).
Enable Data Formatter, Not Required, Drop Prefix/Suffix: Scanned data that meets your data format requirements is
modified accordingly and gets outputted without prefixes and suffixes (even if prefix and suffix are enabled). Barcode data
thatdoesnotmatchyourdataformatrequirementsistransmittedasreadalongwithprefixesandsuffixes(ifprefixandsuffix
areenabled).
189
** Disable Data Formatter
Enter Setup
** Exit Setup