AudioCodes Mediant 2000 Installation Manual page 19

Fast Track Installation Guide
Note:
6. Map outgoing calls to IP addresses (when Gatekeeper isn't used) by completing these steps:
Click the arrow button next to the 'Tel to IP Routing Table' label; the 'Tel to IP Routing'
screen opens.
Any telephone number that its destination number matches the prefix defined in the
'Destination Phone Prefix' field and its source number matches the prefix defined in the
adjacent 'Source Phone Prefix' field, is sent to the IP address entered in the 'IP Address'
field.
Click the SUBMIT button; the 'Tel to IP Routing' table is automatically updated.
Click the Close Window button.
For more information on the 'Tel to IP Routing' table refer to the H.323 Mediant 2000 User's
Manual.
7. Enable E1/T1 B-channels by completing these steps:
Click the arrow button next to the 'Trunk Group Table' label; the 'Trunk Group Table'
screen opens.
Select the number of the trunk you want to enable from the 'Trunk ID' drop-down list.
Enter the number of B-channels you want to enable in the 'Channels' field.
Enter the starting phone number in the adjacent 'Phone Number' field (these are virtual
numbers, used only to define enabled B-channels).
Click the SUBMIT button; the 'Trunk Group Table' table is automatically updated.
Close the Window.
8. Click the Reset button and click OK in the prompt; The Mediant 2000 applies the changes
and restarts. This takes approximately 60 seconds to complete. When the Mediant 2000 has
finished restarting, the Ready and LAN LEDs on the front panel are lit green.
9. After the gateway is reset, configure the Mediant 2000 trunk parameters. For information on
configuring the trunk parameters, refer to Section
You are now ready to start using the VoIP gateway.
Version 4.4
The preferred coder is the coder that the Mediant 2000 uses as a first choice
for all connections. If the far end gateway does not use this coder, the
Mediant 2000 will negotiate with the far end gateway to select a coder that
both sides can use.
3.5 on page 22.
19
3. Initializing the Mediant 2000
August 2004