Initializing The Mediant 2000; Initialization Procedure; Table 3-1: Mediant 2000 Default Ip Address & Subnet Mask - AudioCodes Mediant 2000 Installation Manual

3

Initializing the Mediant 2000

AudioCodes' Mediant 2000 application software already resides in the device's flash memory
when it is supplied (with factory default parameters). Mediant 2000 devices are also supplied with
an Embedded (integrally stored) Web Server.
The following procedure describes how to set up the Mediant 2000 with basic parameters using a
standard Web browser (such as Microsoft
Note:
3.1

Initialization Procedure

To initialize the Mediant 2000 take these 12 steps:
1. Before initializing, connect your computer to the Mediant 2000 , follow the procedure
described in Section
2. Change your PC's IP address and subnet mask to correspond with the Mediant 2000 factory
default IP address and subnet mask, shown in
address and subnet mask of your PC, refer to Windows™ Online Help (Start>Help).
Table 3-1: Mediant 2000 Default IP Address & Subnet Mask
Mediant 2000
Single module
Double module
Default subnet mask is 255.255.0.0, default gateway IP address is 0.0.0.0
Note:
3. Open a standard Web-browsing application such as Microsoft™ Internet Explorer™ (Version
6.0 and higher) or Netscape™ Navigator™ (Version 7.0 and higher).
4. In the URL field, specify the IP address of the first module of the Mediant 2000 (i.e.,
http://10.1.10.10); the Embedded Web Server's 'Enter Network Password' screen appears,
shown in
Mediant 2000
Section 3.1 applies equally to MGCP/MEGACO/H.323/SIP.
2.3.2 on page 11.
10.1.10.10 (Trunks 1-8) and 10.1.10.11 (Trunks 9-16)
The two IP addresses (one IP address for Trunks 1-8 and one for Trunks 9-
16) refer to two different modules (AudioCodes' TPM-1100 ) that reside in the
same board (AudioCodes' TP-1610 ) inside the Mediant 2000 .
Figure 3-1.
TM
Internet Explorer).
Table 3-1. For details on changing the IP
Default IP Address
10.1.10.10
14
Mediant 2000
Document #: LTRT-70102