Wolf M Series Design Manual page 86

Outdoor Grills | Modules
Planning Information
For portable applications, Wolf Grill carts are designed
specifically to fit Grill models ICBOG30, ICBOG36, and
ICBOG42 and the Side Burner. Model ICBOG54 is designed
for built-in applications only.
For built-in applications, Wolf Outdoor Grills and the
Burner Module are designed for easy placement into a
built-in enclosure. For Outdoor Grills, installation in a
combustible enclosure requires an insulating liner. For
the Burner Module, an insulating liner is not required. The
enclosure should be built according to specifications for
your specific installation on the following pages. If the
Burner Module is installed next to an Outdoor Grill, a mini-
mum of 305 mm is required between the units. A rotisserie
side conversion kit is available from an authorized Wolf
dealer.
Optional stainless steel accessory doors and drawers are
available for built-in applications. Refer to pages 90–94.
Grill carts, insulating liners, and stainless steel doors and
drawers are avail able through an authorized Wolf dealer.
86 | English
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
The electrical outlet must be located within reach of the
power cord. A separate circuit servicing only this appliance
is required.
IMPORTANT NOTE: A ground fault circuit interrupter
(GFCI) or residual current device (RCD) is required to
reduce the risk of electrical shock.
ELECTRICAL REQUIREMENTS (GRILL / MODULE)
Electrical Supply
Service
Receptacle 3-prong grounding-type (earthed), IEC inlet
ELECTRICAL REQUIREMENTS (ROTISSERIE)
Electrical Supply—Input
Electrical Supply—Output
Service
Receptacle barrel plug, 2.1 mm ID x 5.5 mm OD
grounded, 220-240 VAC, 50/60 Hz
grounded, 220-240 VAC, 50/60 Hz
12 VDC
0.5 A (6 Watts)
1 A