Wolf M Series Design Manual page 103

Downdraft Systems
Planning Information
Wolf Downdrafts can be installed with most Wolf Cook-
tops, but are not compatible with the Grill and Steamer
Modules. Contact an authorized Wolf dealer for details.
For installation with a Wolf Cooktop, a minimum 638 mm
deep flat countertop is required.
The remote-mounted control module must be located
within 2.7 m of the Downdraft assembly and a minimum
76 mm from the edge of the cooktop cutout.
BLOWERS
Internal and remote blowers are available through an
authorized Wolf dealer. Refer to Ventilation Suggestions on
pages 110–112.
Internal blowers include a 152 mm round discharge and
can be front or rear mounted. It can be discharged in any
direction by rotating the blower box. Remote blowers
include a 254 mm discharge and can be discharged from
the front or rear.
Consult a qualified HVAC professional for specific installa-
tion and ducting applications.
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
Certain installations may require that the electrical supply
be placed in an adjacent cabinet.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
220-240 V AC, 50 Hz
220 V AC, 60 Hz
1.9 A
grounding-type (earthed)
.8 m
subzero.com | 103