Wolf M Series Design Manual page 8

M Series Ovens
Planning Information
The M Series Oven can be installed in a standard or flush
inset application. If a cooktop is installed above an oven, a
minimum of 6 mm is required between the units. Loca-
tion of the electrical supply within the oven opening may
require additional cabinet depth.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Single Oven
Double Oven
TRIM OVERLAP
Top
Bottom
Sides
8 | English
DUAL INSTALLATION
Two 76 cm single M Series Ovens can be installed side by
side in a standard or flush inset application. A dual instal-
lation kit is required. To maintain appropriate airflow, the
ovens must be installed into one opening. Any cosmetic or
structural material placed between the ovens will impede
airflow and is not recommended. Refer to the illustrations
on the following pages.
The dual installation kit is available through an authorized
Wolf dealer.
MIN
115 kg
181 kg
25 mm
0 mm
18 mm