Wolf M Series Design Manual page 60

Coffee Systems
Planning Information
The Coffee System can be installed in a standard or flush
inset application. The sides of the cabinet opening must
be adequate to support installation of the mounting slides.
Refer to the illustration below.
Finish the edges of the opening.
For standard installations, the face trim overlaps stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. Each corner of the opening must be
exactly 90° to maintain consistent reveals.
INSTALLATION REQUIREMENTS
Coffee System
TRIM OVERLAP
Top
Bottom
Sides
COMBINATION INSTALLATION
If a Coffee System is installed above a Cup Warming
Drawer, specify one opening for both units. To achieve
the minimum reveal between the units, place the Coffee
System support rails on top of the Cup Warming Drawer,
then secure the rails to the sides of the cabinet. Any mate-
rial between the units will increase the horizontal reveal
between the two products.
19 mm
TYPICAL
356
mm
76 mm
Side support
60 | English
45 kg
60 cm MODEL 76 cm MODEL
5 mm 5 mm
0 mm 0 mm
18 mm 98 mm
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
220-240 V AC, 50/60 Hz
1350 W
grounding-type (earthed)
1.8 m