Wolf M Series Design Manual page 82

Sealed Burner Rangetops
Planning Information
The platform to support the Sealed Burner Rangetop must
include a cutout for electrical and gas supply connections.
Refer to the chart below for minimum base support.
When installing against a combustible surface, a minimum
254 mm riser is required for 91 cm and 122 cm Sealed
Burner Rangetops with a charbroiler or griddle. Follow all
minimum clearances to combustible surfaces shown in
the illustration on the following page. Models ICBSRT362W
and ICBSRT484W cannot be installed against a combus-
tible surface.
A Wolf Pro Ventilation Hood is recommended with the
Sealed Burner Rangetop. Refer to page 106 for Pro
Ventilation.
INSTALLATION REQUIREMENTS
PLATFORM
Thickness
BASE SUPPORT
91 cm Rangetop
122 cm Rangetop
82 | English
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply within the shaded area shown
in the illustration on the following page. A separate circuit
servicing only this appliance is required.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
GAS SUPPLY
19 mm
Installation must conform with all applicable gas codes.
MIN
A gas supply line of 19 mm rigid pipe must be provided
113 kg
to the rangetop. If local codes permit, a certified, .9 m
136 kg
long, 13 mm or 19 mm ID flexible metal appliance con-
nector is recommended to connect the units ISO 7/1-14
female inlet to the gas supply line.
Wolf natural gas rangetops will function up to 3124 m in
altitude without adjustment and LP gas ranges will func-
tion up to 2621 m. If the installation exceeds these eleva-
tions, contact an authorized Wolf dealer for a high altitude
conversion kit.
GAS REQUIREMENTS
NATURAL GAS
Supply Pressure
LP GAS
Supply Pressure
grounded, 220-240 VAC; 50/60 Hz
grounding-type (earthed)
25 mbar
37 mbar
0.2 A
2 m
WC
WC