Wolf M Series Design Manual page 38

Warming Drawers
Planning Information
The Warming Drawer must be installed with a Wolf drawer
front, avail able through an authorized Wolf dealer. Specific
installation instructions are included with the drawer front.
The Warming Drawer can be installed in a standard or flush
inset application.
For a standard installation, the drawer collar and front
panel sit proud of the cabinet face frame. A recessed
installation requires the cabinetry be recessed by 5 mm
so the collar is flush with the cabinet face frame but the
drawer front will sit proud. A flush inset installation requires
the drawer collar and front panel be recessed to be flush
with surrounding cabinetry. Refer to the illustrations on the
following pages for minimum cabinet dimensions for your
specific installation.
Finish the edges of the opening. They may be visible when
the drawer is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
Minimum Base Support
Trim Overlap (top, bottom, sides)
38 | English
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
Locate the electrical supply flush with the back wall and
within the shaded area shown in the illustrations on the
following pages. For ease of installation, the electrical
supply for the Warming Drawer can be placed in an
adjacent cabinet within reach of the power cord.
ELECTRICAL REQUIREMENTS
Electrical Supply
Service
Receptacle
Power Cord
90 kg
16 mm
220-240 V AC, 50/60 Hz
850 W
grounding-type (earthed)
.9 m