Table of Contents
Advertisement
6. Push the ENTER key to accept a new value. If you want to leave
the parameter value unchanged, exit the edit state by pushing the
CANCEL key.
Figure 2.20 – Changing Parameters
Setting Range Limits
If the given parameter setting values are out-of-range values, a
fault message will be shown when the setting is confirmed with
the ENTER key. Adjust the setting to be within the allowed range.
Figure 2.21 – Example of a Fault Message
The allowed setting range is shown in the display in the setting
mode. To view the range, push the INFO key. Push the
CANCEL key to return to the setting mode.
Local Panel User Interface
857-UM001A-EN-P – July 2009
2-23
Advertisement
Table of Contents
