Table of Contents
Advertisement
Item
WAN Interface
Supported Versions
Remote Access IP
SNMP Port
Save
Undo
The SNMP allows you to custom your access control for version 1 and version 2
user. The router supports up to a maximum of 10 community sets.
Figure 3.142 Administration > Configure & Manage > SNMP
When Add button is applied, the Multiple Community Rule Configuration screen
appears.
Figure 3.143 Administration > Configure & Manage > SNMP > Multiple
The following table describes the items in the previous figure.
Item
Community
Enable
Description
Specify the WAN interface that a remote SNMP host can access to
the device.
By default, All WANs is selected, and there is no limitation for the
WAN interface.
Select the version for the SNMP
When check the v1 box: It means you can access SNMP by
version 1.
When check the v2c box: It means you can access SNMP by
version 2c.
When check the v3 box: It means you can access SNMP by
version 3.
Specify the remote access IP for WAN.
Select Specific IP Address, and fill in a certain IP address. It
means only this IP address can access SNMP from LAN/
WAN side.
Select IP Range, and fill in a range of IP addresses. It means
the IP address within specified range can access SNMP from
LAN/WAN side.
If you left it as blank, it means any IP address can access SNMP
from WAN side.
Specify the SNMP port. You can fill in any port number. But you
must ensure the port number is not to be used.
Value Range: 1 ~ 65535.
Click Save to save the settings.
Click Undo to cancel the settings.
Community Rule Configuration
Description
Specify this version 1 or version v2c user's community that will be
allowed Read Only (GET and GETNEXT) or Read-Write (GET,
GETNEXT and SET) access respectively. The maximum length of
the community is 32.
Click Enable checkbox to enable this version 1 or version v2c
user.
101
EKI-6333AC-4GP User Manual
Advertisement
Table of Contents
