Ipv6; Figure 3.71 Basic Network > Ipv6 > Configuration - Advantech EKI-6333AC-4GP User Manual

Idustrial ieee 802.11 a/b/g/n/ac wi-fi ap with poe
Table of Contents

Advertisement

Item
Encryption
MAC Address
Priority
Enable
Save
Undo
Back
3.3.4

IPv6

3.3.4.1
Configuration
To access this page, click Basic Network > IPv6 > Configuration.
The following table describes the items in the previous figure.
Item
IPv6
WAN Connection Type
EKI-6333AC-4GP User Manual
Description
Select a suitable encryption method and enter the required key(s).
The available method in the drop-down menu depends on the
Authentication you selected.
None: It means that the device is open system without
encrypting.
WEP: Up to 4 WEP keys can be set, and you have to select
one as current key. The key type can set to HEX or ASCII. If
HEX is selected, the key should consist of (0 to 9) and (A to
F). If ASCII is selected, the key should consist of ASCII table.
TKIP: TKIP was proposed instead of WEP without upgrading
hardware. Enter a pre-shared key for it. The length of key is
from 8 to 63 characters.
AES: The newest encryption system in WiFi, it also designed
for the fast 802.11n high bitrates schemes. Enter a pre-
shared key for it. The length of key is from 8 to 63 characters.
You are recommended to use AES encryption instead of any
others for security.
Specify the MAC address of the access point (with the network ID)
to be connected to.
Specify a priority setting for the uplink profile when the By User-
defined methodology is selected. The priority value can be 1 ~ 16.
1 is the highest priority, and 16 is the lowest priority).
Click the Enable checkbox to activate this profile.
Click Save to save the settings.
Click Undo to cancel the settings.
Click Back to return the previous screen.
Figure 3.71 Basic Network > IPv6 > Configuration
Description
Check Enable checkbox to activate the IPv6 function.
Define the selected IPv6 WAN Connection Type to establish the
IPv6 connectivity.
Select Static IPv6 when your ISP provides you with a set
IPv6 addresses. Then go to Static IPv6 WAN Type
Configuration.
Select DHCPv6 when your ISP provides you with DHCPv6
services.
Select PPPoEv6 when your ISP provides you with PPPoEv6
account settings.
Select IPv6 when you want to use IPv6 connection.
Note:
For the products just having 3G/4G WAN interface, only
IPv6 is supported.
62

Advertisement

Table of Contents
loading

Table of Contents