Huawei UPS2000-G-6KRTLL User Manual page 12

UPS2000-G-6KRTLL
User Manual
It is recommended that an independent battery room be used. Before installing
battery modules, prepare fire extinguishing facilities, such as firefighting sands
and liquid carbon dioxide fire extinguishers, according to the construction
regulations. Before operation, ensure that the battery room is equipped with a fire
extinguishing system that complies with local regulations.
Before unpacking battery modules, ensure that the packing cases are intact and
correctly placed according to the labels on the packing cases during their storage
and transportation. Do not place a battery module upside down, lay it on one side,
or tilt it. Stack the battery modules according to the stacking requirements on the
packing cases. Any bumping or falling may damage the battery modules.
After unpacking battery modules, place them in the required direction. Do not
place a battery module upside down or vertically, lay it on one side, tilt it, or stack
it with other modules. Any bumping or falling may damage the battery modules.
Install the equipment in an area far away from liquids. Do not install it under
areas prone to condensation, such as under water pipes and air exhaust vents, or
areas prone to water leakage, such as air conditioner vents, ventilation vents, or
feeder windows of the equipment room. Ensure that no liquid enters the
equipment to prevent faults or short circuits.
● Battery modules should be used soon after being deployed. For battery
● After the battery system is installed, fully charge batteries (the SOC reaches
● If the battery system is powered off for installation or commissioning or
Issue 02 (2022-06-30)
WARNING
WARNING
WARNING
WARNING
CA UTION
modules that have been stored for an extended period, recharge them
periodically according to the instructions for battery module recharge.
Otherwise, the battery modules may be damaged.
100%) and then put them into use. Exercise caution to replace a battery
module unless it is faulty.
batteries are not charged in time after discharge, recharge the battery cabinet
in time by referring to the instructions for recharging batteries with low SOC.
Otherwise, batteries may be damaged due to overdischarge.
Copyright © Huawei Technologies Co., Ltd.
1 Safety Information
6