Table of Contents
Advertisement
Troubleshooting
Troubleshooting
WARNING
REMOTE ACTIVATION HAZARD
The equipment can be activated remotely.
Unexpected activation could result in serious injury,
such as skin injection. To reduce risk of serious injury,
ensure that hands are clear of dispensers.
PRESSURIZED FLUID HAZARD
This equipment stays pressurized until pressure is
manually relieved. Before cleaning, checking, or
servicing the fluid components, follow the Pressure
Relief procedure in the ProDispense operation
manual (3A3469).
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the
work area to help prevent serious injury, including eye
injury, hearing loss, inhalation of toxic fumes, and
burns.
Common Troubleshooting Issues
For more detail, refer to the Banner Engineering manual shipped with your 26C266 Wireless Remote Kit.
Problem
The radio won't wake up.
The sensors are not powered.
20
Cause
While in Storage mode, the radio
does not operate. All Sure Cross®
radios powered from an integrated
battery ship from the factory in
storage mode to conserve the
battery.
Many SureCross devices have
several switch power outputs for
powering sensors.
1. Follow Troubleshooting, page 20, before checking
or repairing devices.
2. Check all possible problems and causes before
disassembling devices.
To wake the device, press and hold button
1 for 5 seconds. To put any FlexPower or
integrated battery Sure Cross radio into
storage mode, press and hold button 1 for 5
seconds. The radio is in storage mode
when the LEDs stop blinking, but in some
models, the LCD remains on for an
additional minute after the radio enters
storage mode. After a device has entered
storage mode, you must wait 1 minute
before waking it.
Enable the power supplies using the I/O
point parameters for sensor supply #,
supply output voltage, and warm-up time.
Solution
3A6715B
Advertisement
Table of Contents
