Table of Contents
Advertisement
1
2
Item Description
1
Left front mount bracket
2
Left rail shelf
3. Loosen, but do not remove, all 4 rail slide set screws on each rail with a Philips screwdriver.
4. Select the left rail, then face the left side of the rack cabinet and slide the front mount bracket pins into the desired slots in
the front rack post.
5. Insert a Phillips-head M5 x 15 screw through the rack post into the center of the front rack mount bracket and barely
tighten against the front rack post, using an 8mm nut driver or a Philips screwdriver.
6
7
Item Description
3
Rail slide set screw
4
Left rear tail
Figure 17 5U left and right rail components
3
Item Description
5
Rear mount
6
Right front mount bracket
Chapter 5 Installation of 5U enclosures
4
5
8
Item Description
7
Rack pin
8
Right rear mount bracket
35
Advertisement
Table of Contents
