Figure 59 Replacement Of Drive In Its Carrier; Figure 60 Release Latch Open And Unlocked; Figure 61 Release Latch Properly Locked - Seagate Exos E 2U12 Series Hardware Installation And Maintenance Manual

Figure 59 Replacement of drive in its carrier

c. Push the DDIC down until the top is flush with the top of the slot.
d. While holding it against the bottom of the slot, slide the top latch toward the rear of the drawer until it locks into place
and the DDIC release latch locks.

Figure 60 Release latch open and unlocked

Figure 61 Release latch properly locked

e. Verify that all drives are at the same level and all DDIC release latches are properly locked.
CAUTION Do not proceed to close the drawer unless all DDICs are in a fully locked position or DDIC height can
inhibit or completely prevent drawer access once you close it.
f. Confirm that the DDIC fault condition LED is off.
86 Chapter 10 In-service field maintenance for 5U enclosures