Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual page 31

[1] Stand at the center of the vehicle lane (position [1] in the figure below) and walk in the
direction of vehicle access. The position where the operation indicator changes from blinking
blue to blinking red (detection status) is the edge of the detection area.
(In normal operation mode, the detection occurs a little ahead of the detection area edge. )
If the detection area is not as expected, adjust the sensor's installation direction and/or the
detection range again.
[2] Stand at the edge of the vehicle lane (position [2] in the figure below), walk along the border
and verify that non-detection status is maintained. (Operation indicator blinks in blue.)
If the operation indicator blinks in a color other than blue (detection status), adjust the
sensor's installation direction and/or detection range, and restart from [1].
[3] After verifying the detection area, press the Area Check button again. By pressing the button,
it switches to normal operation mode, and the operation indicator turns to solid blue.
* If it keeps blinking in blue (non-detection status) for 30 seconds, it will automatically
change back to normal operation mode.
After verifying the detection area, use a vehicle to check the entire operation of the parking space devices.
For the operation check, verify proper operation with a vehicle parked on the left side, center, and right side of
the lane.
Left side of the lane
Center of the lane
Right side of the lane
Blinking red
Continues to blink in blue
-31-
[1]
[2]
Gate bar
Gate bar