Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual page 21

7
Setting Verification and Adjustment (Using the Application)
7-1
How to Use the Application
To start operation, the application must be used.
When using it for the first time, refer to "3 Settings (Application)" (p. 4), and verify and
change the setting.
1
Log in to the sensor
Start up the application, and go to Log in using one of the following procedures.
1. Select the target sensor from the list.
2. Press the QR Code icon, and read the QR code on the sensor top.
2
Manage the sensor password
When logging into the sensor for the first time, set a login password for the sensor with
reference to the precautions.
Manage passwords carefully to avoid breaches and loss.
If a password is lost, long press (5 seconds or more) the Reset switch, and reset to the
factory settings.
The password can then be changed.
7-2
Icons
Below are the icons used in the application.
QR code: This is used to log in to the sensor, or to share Favorites.
Folder: This is used to read a QR code that has been saved onto a smartphone.
Save: This is used to save QR codes and Favorites.
Send: This is used to transmit settings to the sensor.
If a red circle appears on the top right of the icon, make sure to press this.
Status: This is used to verify sensor operation. If a red circle appears on the top right of
Parameter: This is used to set sensor parameters. If a red circle appears on the top right
Input and output: This is used to set sensor inputs and outputs. If a red circle appears on the
Information: This is used to verify or edit sensor information.
the icon, make sure to perform the "Send" operation.
of the icon, make sure to perform the "Send" operation.
top right of the icon, make sure to perform the "Send" operation.
-21-