Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual page 18

Vehicle detection sensor

Hide thumbs Also See for ViiK Exposed Type OVS-02GT Series:

Table of Contents

[5] Install the sensor unit into the base.

[6] Rotate the sensor unit to adjust its angle to meet the

sensor installation condition (adjustable angle: 96° to

left and right).

Using the smartphone application

[7] Verify the detection area according to "Selecting an Application" (p. 27) and "Main Parameters" (p. 27) as

well as "8-4 Detection Area Check" (p. 29).

[8] Attach the top and bottom covers.

[9] Tighten the screws on the top and bottom covers.

* If a screw is lost, use an M3 × 6 Philips screw.

[10] Perform calibration according to "8-3 Calibration" (p. 28).

[11] Verify the system operation according to "8-4 Detection Area Check" (p. 29).

-18-

Table of Contents

Need help?

Do you have a question about the ViiK Exposed Type OVS-02GT Series and is the answer not in the manual?

Viik embedded type ovs-02b series