Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual page 30

[1] Stand at the center of the vehicle space (position [1] in the figure below), and walk in the
direction the vehicle will move. The position where the operation indicator changes from
blinking blue to blinking red (detection status) is the edge of the detection area.
(In normal operation mode, the detection occurs a little ahead of the detection area edge. )
If the detection area is not as expected, adjust the sensor's installation direction and/or the
detection range again.
[2] Stand at the edge of the vehicle lane (positions [2] and [3] in the figure below), walk along the
border and verify that non-detection status is maintained. (Operation indicator blinks in blue.)
If the operation indicator blinks in a color other than blue (detection status), adjust the
sensor's installation direction and/or detection range, and restart from [1].
[3] After verifying the detection area, turn OFF area check mode. By turning it OFF, the mode
switches back to normal operation mode and the operation indicator turns to solid blue.
* If the operation indicator keeps blinking in blue (non-detection status) for 30 seconds, it will automatically
change back to normal operation mode.
After verifying the detection area, use a vehicle to check the entire
operation of the parking space devices.
For the operation check, park a vehicle on the center and at four
corners, and verify proper operation.
Blinking red
Continues to
blink in blue
Check the operation by parking
-30-
[1]
Sensor installation position:
vehicle space corner
[2] [3]
Sensor installation position:
vehicle space corner
near the four corners of
the vehicle space
[1]
Sensor installation position:
vehicle space center
[ ] [2] [ ] [3]
Sensor installation position:
vehicle space center