Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual page 19

6-3
Installation of the Embedded Type OVS-02B Series
[1] Loosen the retaining screws on the bottom of the front case and remove the front case.
Do not loosen the screw completely. The screw may fall out.
If a screw is lost, use an M3 × 10 Philips screw.
Enclose the base to the pole.
[3] Secure the base using mounting brackets.
[3]-1
Insert the mounting brackets diagonally by
hooking them upwards.
[4] Connect wires to the terminals. Refer to page 6
Connect the power supply to the power supply terminals, and relay output cables to the output terminals.
When linking to other devices or when a connected billing machine has billing information outputs,
connect the other device to the input terminals.
Cut the rubber bump with scissors and make a hole according to the wire diameter. (Select the smallest
from among similar sizes.)
[3]-2
Slide the mounting brackets.
Wiring size: ø2–6mm
(0.08–0.24in.)
-19-
[3]-3
Tuck the sensor into the pole surface
and secure it with screws.
Only cut the front end using scissors or nippers.
Doing so will avoid making a hole that is too big.