Detection Area Check - Optex ViiK Exposed Type OVS-02GT Series Installation Instructions Manual

8-4

Detection Area Check

This function allows you to virtually check the invisible detection area using indicators on the
application or the operation indicator.
It is possible to verify the correct angle and size of the detection area.
During this process, the human cancellation function is disabled, and any moving vehicles
and pedestrians are detected.
* Be sure to perform the area check after transmitting the settings and performing calibration.
On the "Status" screen of the application, turn ON the area check mode. The mode changes
to detection area check mode, and the operation indicator blinks in blue.
(If the operation indicator keeps blinking in blue for 30 seconds, the mode goes back to
normal operation mode. )
If there is a pedestrian or object within the detection area, the operation indicator's color
changes to yellow or red.
(The operation indicator's color changes depending on the detection condition.)
If it is not blinking in blue, remove the object to outside of the detection area, and confirm that
the indicator blinks in blue.
If the operation indicator is blinking in yellow while there is no pedestrian or object in the
detection area, perform calibration again.
During normal area check mode
* The on-delay/off-delay setting is not applied during the detection area check mode.
NOTE
Countermeasures during area check mode
degraded. If an object in the detection area can be removed, be sure to do so as
a countermeasure.
CAUTION
sensor's installation angle and securely attach its covers with screws, set the detection range again,
and be sure to perform calibration.
Blinking blue
When there is a pedestrian or an object
-29-
Blinking red
Blinking yellow