Display And Control Elements - Conrad Electronic 75 15 32 Operating Instructions Manual

5. Display and control elements

See front fold-out page for illustrations of the following description.
The following numbers denote display and control elements:
1) DC IN 12V 0.5A socket
Voltage supply connection. Connect the low voltage plug of the included wall power supply here.
2) Cable hole
Intended for cable passage.
3) Anti-tamper contact
The anti-tamper contact triggers the TAMPER relay contact when the housing is opened.
4) Connection terminals
The screw terminals are called TAMPER, VIDEO +, COM, VIDEO - and RELAY (see chapter "6.3
Connection").
5) Camera
6) Status LED (rot)
The behaviour of the status LED (red) is explained the the respective chapters.
7) 3 motion detectors (PIR)
The three motion detectors cover a horizontal range of approx. 180°.
8) Fixing screw
This screw has to be loosened to open the housing.
9) Mounting holes
Before installation, the premarked mounting holes have to be opened using a suitable drill.
10) Function selector switch S1
This switch allows you to select the desired function (see chapter "Function selector switch").
21