Status Led (6); Settings And Functions Of Function Selector Switch S1 (10) And Position Selector Switch S2 (11) - Conrad Electronic 75 15 32 Operating Instructions Manual

7. Status LED (6)

The Status LED (6) flashes for 60 seconds after the position of function selector switch S1 (10) has been
changed.
When motion is detected, the status LED (6) flashes for 10 seconds.
See chapter 8 to read about the behaviour of the status LED (6).
8. Settings and functions of
function selector switch S1 (10) and
position selector switch S2 (11)
a) Function selector switch S1 (10)
Function selector switch S1 (10) in position 1:
In this position the RELAY contact of the terminal (4) is closed constantly. When motion is detected, the
red status LED (6) does not flash and the RELAY output is not triggered.
The camera switches between the 5 different camera positions at an interval of one second (regardless
of the setting of position selector switch S2 (11)).
Function selector switch S1 (10) in position 2:
In this position the RELAY contact of the terminal (4) is closed.
When motion is detected by one of the motion detectors (7), the camera moves to the corresponding
position and the RELAY contact is triggered. The RELAY contact is active for 10 seconds (while the red
status LED (6) flashes).
If there is no motion after ten seconds, the camera moves back to its original position (as set by position
selector switch S2 (11)) and the red LED stops flashing.
25