Table of Contents
Advertisement
Page 98 of 126
Configuration menu
Table 68
Port Bypass menu
Command
enable
disable
portlist
NN10300-091
Standard 1.00
Port Bypass menu
Using the Port Bypass menu (/cfg/smc/settings/portbypass), you can identify
a specific set of TCP ports for which you want the SMC's stateful processing
to bypass. You can add, modify, and delete the IP addresses for the TCP ports
you want to bypass. When the Port Bypass feature is enabled, the SMC does
not process or check all packets matching the port list.
The default entry in the port list is the IP address, 0.0.0.0, which indicates
every TCP port is bypassed when the Port Bypass feature is enabled.
Alternatively, you can add IP addresses of the specific TCP ports you want
the SMC to bypass. You can configure up to a maximum of four sets of port
and IP addresses.
Table 68 identifies and describes the Port Bypass menu commands.
Description
Enables the Port Bypass feature.
Disables the Port Bypass feature.
Displays the Port List menu, which you can use to add, modify, or delete IP
addresses to the list of port list. For menu commands, see "Port List menu"
on
page
99.
May 2006
Advertisement
Table of Contents
