Table of Contents
Advertisement
Table 15
Cluster Host menu (/cfg/sys/cluster/host <cluster host number>)
Command
ip <host IP address>
name
licence
Cluster Host menu
Using the Cluster Host menu (/cfg/sys/cluster/host), you can change
parameters for the SMC host. To identify the host number, use the
/cfg/sys/cluster/cur command.
Table 15 identifies and describes the Cluster Host menu commands.
Description
Specifies the IP address of the selected host. Changing this address
does not affect the cluster MIP address that defines the cluster. After
you apply the new IP address using the Apply command, the system
logs you off.
Specifies a name for each SMC. When you log on as the
administrator, the name of the SMC appears as part of the banner.
Allows you to enter a Secure UNIStim license into the SMC cluster.
The license parameter determines how many Secure UNIStim users
are supported by the SMC. The license is associated with the MAC
address of port 1 on the SMC.
To enter a license, follow the prompts and paste the license string
directly into the CLI. When complete, press <Enter> to go to a new
line and then type three periods (...) to terminate the command
sequence. The license will be automatically stored on the particular
SMC.
In an HA cluster, two licenses are required to support secure UNIStim:
one on each SMC in the cluster.
Note 1: The license restriction applies only to secure UNIStim users.
Note 2: Type cur within the Cluster Host screen to see the current
license for the SMC.
Configuration menu
Secure Multimedia Controller
Page 37 of 126
Command Reference
Advertisement
Table of Contents
