Table of Contents
Advertisement
Boot menu
Table 84
Boot menu
Command
software
halt
reboot
delete
You can use the Boot menu (/boot) to upgrade the SMC software and to
reboot, if necessary. The Boot menu is only accessible using an administrator
login.
Table 84 identifies and describes the Boot menu commands.
Description
Displays the Software Management menu, which you can use to load,
activate, or remove SMC software upgrade packages. For menu items, see
"Software Management menu" on
Stops the SMC. Use this command only before you turn off the SMC If you
are using Telnet or SSH, use this command only after you connect to the
SMC host IP address. If you do not enter the Halt command before
powering off the SMC, the configurations can be lost and the SMC can
reset to factory default settings.
Reboots the SMC. When you are using Telnet or SSH, use this command
only after you connect to the SMC host IP address.
Resets the SMC to its factory default configuration. If you are using Telnet
or SSH, use this command only when you are connected to the SMC host
IP address.
After you reset the SMC to factory defaults, you can access the device only
through a console terminal attached directly to the local serial port. You can
then log on using the administration account (admin) and the default
password (admin) to access the initial Setup utility.
page
114.
Secure Multimedia Controller
Boot menu
Page 113 of 126
Command Reference
Advertisement
Table of Contents
