Routes menu
Table 52
Route menu (/cfg/net/route)
Command
list
del <index number>
add <destination IP address>
<destination mask>
<gateway IP address>
insert <index number>
<destination IP address>
<destination mask>
<gateway IP address>
move <index number>
<destination index number>
VRRP Settings menu
Using the Routes menu (/cfg/net/route), you can add, delete, or list static
routes. The SMC uses these static routes to route transmit packets to
indirectly attached internal networks. You can configure up to 1000 static
routes.
Table 52 identifies and describes the Route menu commands.
Description
Lists all configured routes by their index number and IP
address information.
Removes a route from the configuration by specifying the
route index number.
Adds a static route based on destination IP address,
destination subnet mask, and gateway IP address.
Note: The gateway IP address must be previously specified
and cannot be within the range specified by the destination
IP address and mask.
Adds a new static route at a specific position (index number)
in the index.
Moves a static route from one position in the index to
another.
Using the VRRP Settings menu (/cfg/net/vrrp), you can configure Virtual
Router Redundancy Protocol (VRRP) parameters for the SMC cluster.
Specify valid addresses for each SMC before you apply changes to the
Configuration menu
Secure Multimedia Controller
Page 77 of 126
Command Reference